3d printed indoor / outdoor vertical hydroponic vegetable and herb growing tower with 24 total growing spaces. 25% of the tower is printed with recycled petg material. Includes integrated led grow light kit. There are 12 3" cups and 12 2" cups. This tower is white and comes with or without a white 5 gallon bucket (note: bucket is not 3d printed).
The tower fully assembled stands at 53 tall and just over 12 in diameter. This kit includes everything you need to get started except for seeds and water. 2-24hr timer which can be set in increments of 15 minutes.Full spectrum sunlight white led bars 90w total (6x15w). 12 2 net pods with peat pellets and covers. 12 3 net pods with peat pellets and covers. 2oz ez grown liquid nutrients. 4 small greenhouses to start your seeds in (color will vary from white, green, black or blue).
Assembly is quick with just a few steps. While i hope you love this item, in the unlikely event that you do not you'll have 60 days to try it out.
If you're unfamiliar with 3d printing here is a quick overview. The 3d printers used for these towers are fff, fused filament fabrication. A small layer of plastic is printed at a time building the model from the base up using a roll of pre-colored filament. Due to this process, there may be slight surface or color irregularities. You'll also see the print lines and seams. Following the printing process models are cleared from any support structures needed and wiped clean. The towers are printed using petg resin with 25% recycled material.Excessively hot temperatures may cause warping which could cause improper component fit. This item is made of polypropylene.