3 15 cup Hydroponic vegetable and herb garden growing tower. Green-Fits 5 gallon bucket. Just add seeds and water

  

3d printed indoor / outdoor hydroponic vegetable and herb growing tower with 15 - 3 growing cups. This tower is green and uses a 5 gallon bucket (from tractor supply) you can opt to supply your own bucket for a $6 savings. (note: plants are not included) the tower fully assembled stands at 51 tall and 12 in diameter. This kit includes a pump, a timer which can be set in increments of 15 minutes, 15 3 net pods, a cleaning brush and a 10ml pipette for liquid nutrients. Assembly is quick with just a few steps.

All you will need to add is the growing medium of your choice, seeds, water, and nutrients. If growing indoors you may need to add a light depending on how much sun you receive.

While i hope you love this item, in the unlikely event that you do not you'll have 60 days to try it out and send it back. If you're unfamiliar with 3d printing here is a quick overview. The 3d printers used for these towers are fff, fused filament fabrication. A small layer of plastic is printed at a time building the model from the base up using a roll of pre-colored filament.

Due to this process, there may be slight surface or color irregularities. You'll also see the print lines and seams.

Following the printing process models are cleared from any support structures needed and wiped clean. The towers are printed using pla resin which is not dishwasher safe, but can be washed using regular dish soap and luke warm water. Excessively hot temperatures may cause warping which could cause improper component fit. This item is made of pla and polypropylene.