There are 3 growing locations per section and 7 sections. When assembled the sections alternate to provide grow height to the section below.
The base has been redesigned to fill in open space to deter animals from trying to drink while still allowing ample drainage. This tower is white and fits a 5 gallon bucket. (note: bucket is not 3d printed and plants/seeds are not included) the tower fully assembled stands at 51 tall and just over 13 in diameter.This kit includes a pump, a timer which can be set in increments of 15 minutes, 21 net pots with 21 jiffy peat pellets for starters, 2oz ez grown liquid nutrients, a 10ml pipette and a cleaning brush. Assembly is quick with just a few steps. All you will need supply are seeds and water.
If growing indoors you may need to add a light depending on how much sun you receive. While i hope you love this item, in the unlikely event that you do not you'll have 60 days to try it out and send it back. Have a suggestion for improvement feel free to let me know. Want a custom color checkout my custom listing for sample colors. If you're unfamiliar with 3d printing here is a quick overview.The 3d printers used for these towers are fff, fused filament fabrication. A small layer of plastic is printed at a time building the model from the base up using a roll of pre-colored filament. Due to this process, there may be slight surface or color irregularities. You'll also see the print lines and seams.
Following the printing process models are cleared from any support structures needed and wiped clean. The towers are printed using pla resin which is not dishwasher safe, but can be washed using regular dish soap and luke warm water. Excessively hot temperatures may cause warping which could cause improper component fit. This item is made of pla and polypropylene.