12 3 net pods with peat pellets. 2oz ez grown liquid nutrients. 4 small greenhouses to start your seeds in (color will vary from white, green, black or blue).
Assembly is quick with just a few steps. While i hope you love this item, in the unlikely event that you do not you'll have 60 days to try it out.
If you're unfamiliar with 3d printing here is a quick overview. The 3d printers used for these towers are fff, fused filament fabrication. A small layer of plastic is printed at a time building the model from the base up using a roll of pre-colored filament. Due to this process, there may be slight surface or color irregularities. You'll also see the print lines and seams. Following the printing process models are cleared from any support structures needed and wiped clean. The towers are printed using pla resin which is not dishwasher safe, but can be washed using regular dish soap and luke warm water. Excessively hot temperatures may cause warping which could cause improper component fit. This item is made of pla and polypropylene.