Height Extender for your AeroGarden Harvest Boost Your Growing Space

  

Give your plants more room to grow with this custom 3d-printed extender tube for the aerogarden harvest or harvest 360. Adding 6 inches of height to your setup, this extender is a practical solution for accommodating taller plants like tomatoes and maximizing your harvest. Increases growing height: adds 6 inches of height to your aerogarden harvest or harvest 360, giving your plants extra space to thrive. The led lamp wire has enough slack for this extension, no need to cut and solder.

Dimensions: 29.8 x 22.75 x 157mm (1.17" x 0.9" x 6.18). Start with the unit powered off, and all plants and water removed from the system. Remove and set aside the original screw at the top of the light post. Next remove the 4 screws on the bottom under the rubber pads, followed by the 3 screws under the light post. Carefully separate the bottom section and twist to remove the light pole. Disconnect the power cable for the light, then run through the extension. Snap the extension into place. Push pole into unit, twist to lock. Now reinsert the 3 screws to hold the light post in place, followed by the 4 remaining bottom screws. Lastly replace the screw at the top of the light post.

Check out my shop for other 3d-printed aerogarden products and supplies to enhance your indoor gardening experience. Proudly 3d-printed in canada, produced on demand to ensure quality and precision while supporting small businesses.

Inspired by the design from stephen88341, licensed under the creative commons - attribution. Give your plants the room they need to flourish order your aerogarden extender tube today. Please note: it is up to you to ensure that this extender is compatible with your aerogarden unit.

I can personally attest to this being a fit for the latest generation of aerogarden harvest. Aerogarden has a tendency to update their models nearly every year, others may be compatible but i can't offer any guarantees. This item is made of pla.