Greenhouses & Hydroponics

Hydroponic Multitower. 4 , 3 , 2 cups. Fits 5 gallon bucket. Just add seeds and water

Hydroponic Multitower. 4 , 3 , 2 cups. Fits 5 gallon bucket. Just add seeds and water
Hydroponic Multitower. 4 , 3 , 2 cups. Fits 5 gallon bucket. Just add seeds and water
Hydroponic Multitower. 4 , 3 , 2 cups. Fits 5 gallon bucket. Just add seeds and water
Hydroponic Multitower. 4 , 3 , 2 cups. Fits 5 gallon bucket. Just add seeds and water
Hydroponic Multitower. 4 , 3 , 2 cups. Fits 5 gallon bucket. Just add seeds and water
Hydroponic Multitower. 4 , 3 , 2 cups. Fits 5 gallon bucket. Just add seeds and water

Hydroponic Multitower. 4 , 3 , 2 cups. Fits 5 gallon bucket. Just add seeds and water    Hydroponic Multitower. 4 , 3 , 2 cups. Fits 5 gallon bucket. Just add seeds and water

3d printed indoor / outdoor hydroponic multitower with 2 sections with 3- 4" cups (6 total) , 2 sections of 3- 3" cups (6 total) and 2 sections of 3- 2 cups (6 total). This tower is white and fits at 5 gallon bucket. The tower fully assembled stands at 48 tall and 12 in diameter. This kit includes a pump, a timer which can be set in increments of 15 minutes, 6-4" net pots, 6-3" net pots, 6-2 net pots, a cleaning brush and a 10ml pipette for liquid nutrients.

Assembly is quick with just a few steps. All you will need to add is the growing medium of your choice, seeds, water, and nutrients. If growing indoors you may need to add a light depending on how much sun you receive.

While i hope you love this item, in the unlikely event that you do not you'll have 60 days to try it out and send it back. Note: plants, seeds, nutrients and growing medium are not included.

If you're unfamiliar with 3d printing here is a quick overview. The 3d printers used for these towers are fff, fused filament fabrication.

A small layer of plastic is printed at a time building the model from the base up using a roll of pre-colored filament. Due to this process, there may be slight surface or color irregularities. You'll also see the print lines and seams. Following the printing process models are cleared from any support structures needed and wiped clean.

The towers are printed using pla resin which is not dishwasher safe, but can be washed using regular dish soap and luke warm water. Excessively hot temperatures may cause warping which could cause improper component fit.

This item is made of pla and polypropylene.


Hydroponic Multitower. 4 , 3 , 2 cups. Fits 5 gallon bucket. Just add seeds and water    Hydroponic Multitower. 4 , 3 , 2 cups. Fits 5 gallon bucket. Just add seeds and water