Hydroponics Tower. 3D Printed, 16 net pot, Original Design. Strong water flow. Best for lettuce, strawberry and pak choi.

  

3d printed using bio-based pla plastic. Great for strawberry, lettuce and pak choi. Requires knowledge of hydroponic nutrients.

Not for environment temperature above 50 celcius. Sealant or any waterproof adhesive needed. Recommended 500l/h set at most restricted waterflow. Use either cotton balls or small rockwool as seedling medium.

Size: 9.6inch x 9.6 diameter, 36.5inches height. This item is made of pla.