Reserved for LJ.

  
3d printed indoor / outdoor vertical hydroponic vegetable and herb growing tower with 24 total growing spaces. 12 3" cups and 12 2" growing cups.

This tower is white and comes with or without a white 5 gallon bucket (note: bucket is not 3d printed and plants/seeds are not included) the tower fully assembled stands at 53 tall and just over 12 in diameter. This kit includes everything you need to get started except for seeds kit includes: a pump, a timer which can be set in increments of 15 minutes, 12 2" net pods with peat pellets, 12 3" net pods with peat pellets, 2oz ez grown liquid nutrients, a 10ml pipette and a cleaning brush. Also includes 3 small greenhouses to start your seeds in and white label tags(color will vary from white, green, black or blue) assembly is quick with just a few steps. All you will need supply are seeds and water.

If growing indoors you may need to add a light depending on how much sun you receive. While i hope you love this item, in the unlikely event that you do not you'll have 60 days to try it out and send it back. If you're unfamiliar with 3d printing here is a quick overview. The 3d printers used for these towers are fff, fused filament fabrication.

A small layer of plastic is printed at a time building the model from the base up using a roll of pre-colored filament. Due to this process, there may be slight surface or color irregularities. You'll also see the print lines and seams. Following the printing process models are cleared from any support structures needed and wiped clean. The towers are printed using pla resin which is not dishwasher safe, but can be washed using regular dish soap and luke warm water.

Excessively hot temperatures may cause warping which could cause improper component fit. This item is made of pla and polypropylene.